Electronics Forum | Thu Jun 14 13:49:04 EDT 2012 | rodrigo
Hi all, We have two Heller ovens, a 1700SX and a 1700D. The 1700SX has the profiles made so when you load them the zones turn on in sequence. First zone top and bottom are on when the profile is loaded then the next (top and bot) start to turn on as
Electronics Forum | Thu Jun 28 09:38:14 EDT 2012 | 14367
PSMN130-200D MOSFET TRANSISTOR D2PAK - failure of some parts led to investigation, oxidization or surface contamination was noticed on remaining parts. The surface contamination could be removed when fingernail was drawn over the bottom terminating s
Electronics Forum | Thu Jun 28 09:38:20 EDT 2012 | 14367
PSMN130-200D MOSFET TRANSISTOR D2PAK - failure of some parts led to investigation, oxidization or surface contamination was noticed on remaining parts. The surface contamination could be removed when fingernail was drawn over the bottom terminating s
Electronics Forum | Mon Aug 06 09:55:32 EDT 2012 | dyoungquist
Techspray makes a liquid called "Eco-Stencil SMT Stencil Cleaner" and also pre-saturated wipes by the same name. We spray the cleaner on the stencil and then use the wipes to clean the paste off of the stencil. Putting 1 wipe in each hand and rub
Electronics Forum | Mon Sep 17 09:47:18 EDT 2012 | mbnetto
Hi, Do you want to replace the SB ou just reflow it again? Do you suspect there is some "colder solder joint" in one of the SB balls ? In my opinion you are heating the board a lot... Did you put some thermocouple on the ball to check the temperat
Electronics Forum | Sat Sep 29 19:04:13 EDT 2012 | e_music
Hello, I have just installed the demo version of GC-Powerplace. Could anyone here walk me through the process to generate pick and place file from gerbers? I don't have solderpaste layer. All I have got is signal layers (top/bottom), soldermask, sil
Electronics Forum | Tue Feb 05 16:06:48 EST 2013 | mlevesque
We are looking for a new BGA rework station. We got an ERSA IR550A and we are not very satisfied. I'm not sure that IR reflow is the better solution because the top-side heating is too large. I think is better with a convection "forced-air" heat.
Electronics Forum | Tue Feb 05 20:31:39 EST 2013 | hegemon
Air Vac DRS25. Hands down the best rework EQ. (my humble opinion, based on my own experience with rework EQ going back 15 years +) Right in your budget. Complete capability for rework. SMD, BGA, POP. Full profiling capability. Massive bottom heati
Electronics Forum | Fri Mar 29 16:29:16 EDT 2013 | aemery
Worked on these for many years as a Speedline FSE, now doing my own thing. You could have motion or alignment issues in the printhead. The setting in the INI could be wrong, but unlikely. Or are you just using the wrong squeegees. Without a stenc
Electronics Forum | Mon Mar 25 10:22:20 EDT 2013 | rgduval
You mentioned that you changed the layout some, and this can be essential in this type of process. If the SMT parts and TH leads have inadequate spacing on the bottom side, shorts may be inevitable (someone else will have to advise what the recommen
