Electronics Forum | Wed Mar 03 07:29:34 EST 2004 | pjc
2D will give you on-line contrast inspection for paste coverage on the land. I would go with 2D on the printer when comparing to an AOI that will do the same contrast inspection. There are systems out there that will check paste hieght and area cover
Electronics Forum | Thu Mar 04 22:52:57 EST 2004 | Roberto Rodriguez
i have a Universal GSM2 machine down and we check all, but are exaust, the problem is the next, when we make Zero axis tha machine say "AXIS HEAD1 Z POSITION ERROR DURING MOVE RELATIVE COMMAND" AND "TIME UP SPINDLES UP". DO YOU HAVE EXPERIENCIES AT T
Electronics Forum | Tue Mar 09 22:13:20 EST 2004 | Ken
What x-ray system are you using? Check out Dage. I bet you have voids...just can't image them. Why the fuss over voids? Voids terminate the crack propegation and can extend the time to failure for creep fatigue. I would not be concerned unless yo
Electronics Forum | Tue Mar 09 12:13:27 EST 2004 | Gabriele
I want just to confirm what Dave suggested you. J-STD-033a, par 6. Boards Rework tells you plenty of useful informations. 6.1 Component removal, RWK and remount 6.1.1 Removal for Failure Analysi 6.1.2 Removal & Remount 6.2 Baking of Populated Boar
Electronics Forum | Fri Mar 12 12:59:50 EST 2004 | babe
Sorry for the late reply, I am an ersa dealer may I suggest mounting an alternative thermocouple attached to a DMM in close proximity to the BGA. See what the differences are in your readings from the DMM and the Digital temp reading on the IR550A. I
Electronics Forum | Fri Mar 12 15:10:13 EST 2004 | dougt
I believe the Falcon vision board that Contact Systems used in their equipment is no longer being made by the manufacturer. I would first call them (most reputable), next check the used equipment guys (be carfull), and lastly ebay (good luck). What
Electronics Forum | Wed Mar 24 10:26:51 EST 2004 | mapell
Daniele The other repsonses have it right. The junction of the wires measures the temperature. If your poduct needs to be re-used I would suggest either kapton tape or aluminim tape(the better of the two). If this is your "golden board" I would
Electronics Forum | Mon Mar 22 19:46:17 EST 2004 | pdeuel
The bottom side is going into reflow somewhare near melting point of solder. Reduce bottom side temprature. Get a good mole so ramp and soak tempratures can be checked on bolth sides of the PCB. The object is to keep bottom side parts from approching
Electronics Forum | Sun Apr 18 06:49:10 EDT 2004 | Nick Prince
You might like to check ou the SSTC at the National Physical labs, in the UK. They have done a lot of research in mixing PB and PB free alloys. Its high Science stuff but intelligable. The upshot seems to be that if you mix PB and PB Free alloys th
Electronics Forum | Wed Apr 28 23:18:09 EDT 2004 | Grant Petty
Hi, Ours are inline, and depending on how you have the conveyers, you might need to use the data sheets to work out placement. If your running the conveyers behind the machine, then most of the machine is in front of the conveyer, so they use more s