Electronics Forum | Thu Mar 02 07:20:11 EST 2017 | emeto
I assume that not all switches are fine, or tuned right. Check sensitivity - some switch might be sensing much earlier, and that's why never goes to actual position.In general their equipment has the right design, but I had to fix each individual pi
Electronics Forum | Tue May 23 03:51:41 EDT 2017 | bukas
i had 2 pumps xD also, propeller size can give you a clue. do some research on turbines of any kind, its same principal. you can have someone check it for you on same machine, i'm sure someone will help.
Electronics Forum | Sun Aug 06 19:05:38 EDT 2017 | zsoden
OK thanks. I had assumed that since the soldering was generally smooth and we were having no issues with bridges that the flux would be operating fine. But there really isn't much left to check so I'll get my profiler fixed (the thermocouple has been
Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Wed Jul 19 02:37:24 EDT 2017 | bukas
Hello everyone, i recently got Ersa ETS 330 wave machine '94. I got it running and heaters and flux pumps are ok, but I have problem with 2nd wave pump. It runs for 10-15 sec and then shuts down with error message on display. I checked bearings and
Electronics Forum | Wed Jul 26 11:13:06 EDT 2017 | jdengler
It can be done and is done all the time. You need to check with your customer about this since you will not have clean square corners along the edge. If they are snapping the boards into a holder they may need the square corners to securely hold th
Electronics Forum | Mon Aug 14 03:38:37 EDT 2017 | spoiltforchoice
The pads in the datasheet should suffice. The TDK part really isn't all that big but its reflow profile indicates it is not exactly the most tolerant device with regards to heat. 245C for 5s is not a lot, I would check very carefully that your profil
Electronics Forum | Sat Dec 16 06:16:14 EST 2017 | sherman
In order to find applicable fume extraction, actually it depends on your application. we would like to ask you to check out: http://widaco.net/ to fine out products that we can provide. Fume extraction units that we provide fall into 2 groups: solde
Electronics Forum | Sat Aug 26 09:40:27 EDT 2017 | v037022
Dear, My current method incluce steps below: 1. take out all screw 2. Put them into alcohol 3. Clean it with bemcot paper which wet by alcohol 4. Dry it by air gun 5. Checking by Dino camera. It took so much time. Now i want to do it automatic to red
Electronics Forum | Wed Jan 03 06:34:40 EST 2018 | buckcho
Hello, we used to repair them fairly easy at my previous company. Many of ours had problems, because operators bad handling. If you have a problem with feeders not lighting up, you better try to switch the pcb from one feeder to another and to check