Electronics Forum | Fri Apr 27 15:44:49 EDT 2007 | jsmith01
Does anyone know of a supplier of titanium edge protectors in the US?
Electronics Forum | Wed Oct 22 13:44:41 EDT 2014 | davef
Distributors have access to large number of connector suppliers * http://www.newyorkerelectronics.com/ * http://www.digikey.com/Connectors * http://www.newark.com * http://www.directindustry.com/industrial-manufacturer/card-edge-connector-93613.h
Electronics Forum | Sun Oct 19 06:42:01 EDT 2014 | timbo292832
im designing a circuit that will require the use of a edge connector so it can connect to another circuit. i need to do this so i can get both micro controllers communicating i have done a bit of research and am thinking about using a pcb manufact
Electronics Forum | Wed Jun 30 10:37:11 EDT 1999 | Boca
We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design). Inste
Electronics Forum | Fri Apr 27 18:20:08 EDT 2007 | coop
Integrated Ideas& Technologies, and Fancort one of these companies should have what your after. good luck
Electronics Forum | Sat Apr 28 11:46:14 EDT 2007 | Tom
I think HMC Hub Material used to have these. http://www.hmcelectronics.com/
Electronics Forum | Wed Sep 08 05:51:24 EDT 2010 | 15009
SIPAD solid solder deposit solves this challenge.
Electronics Forum | Thu Sep 23 15:52:00 EDT 2010 | aj
thanks everyone... Not running huge volumes at the moment but all comments are greatly appreciated. aj...
Electronics Forum | Fri Sep 17 13:32:42 EDT 2010 | davidd1
AJ, I am the manager of Samtec's Interconnect Processing Group. The edge mount connector in question does present a set of unique assembly challenges but I am confident we can help you develop a process that fits your needs. Please contact our g
Electronics Forum | Mon Sep 06 09:03:45 EDT 2010 | aj
Hi all, Looking for some advice on how to run this component through the SMT process or is it always hand soldered? Part number is HSEC8-120-01-S-D-EM2 We are currently handsoldering. aj...
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
