Electronics Forum | Thu Jul 01 16:57:36 EDT 2004 | matt7768
could help you if still requirement. Get in touch
Electronics Forum | Thu Mar 11 09:47:26 EST 2004 | johnchung
Hi Allan You need a feeder 44 from Hover-Davis.
Electronics Forum | Mon Mar 08 09:42:22 EST 2004 | davef
Download J-STD-033 from the JEDEC web site.
Electronics Forum | Tue Mar 09 17:58:09 EST 2004 | davef
Vijay: Questions are: * Where are the shorts occuring? * Would you please describe your preheat / underside heating methods?
Electronics Forum | Mon Mar 08 20:22:05 EST 2004 | davef
Wayne: Please describe the location and angle and direction of the crack relative to the board.
Electronics Forum | Mon Mar 08 21:50:16 EST 2004 | John Soileau
I expierenced this while at I-PAC Manuf. when the reflow profile was too hot in the perheat & soak zones.
Electronics Forum | Wed Mar 10 19:50:42 EST 2004 | Ken
check out KIC Thermal Profiling....good, simple tool to use for profiling.
Electronics Forum | Tue Mar 09 22:41:50 EST 2004 | pdeuel
Frustrations to relieve try a sledge hammer.
Electronics Forum | Wed Mar 17 14:59:53 EST 2004 | Claude_Couture
since there is a bit of humor in this thread, try drilling the pads from the opposite side of the pcb.