Electronics Forum | Mon May 22 21:30:55 EDT 2000 | ScottM
Thank you much folks! I've printed out these messages and will be acting on it with management. Interesting that I don't get hazardous waste manifests from the dross recycler but I do with my CLS chemicals for the washers (hummm....). I might ad
Electronics Forum | Tue May 16 16:32:38 EDT 2000 | Ashok Dhawan
1) I had downloaded ANSI/ESD-S20.20-1999 from www.eosesd.org web site. I am not clear whether section 6.2.3.2 is correct. It states that " All process essential insulators that have electrostatic fields that exceed 2000 volts should be kept at a mi
Electronics Forum | Thu May 25 18:58:49 EDT 2000 | Mukesh Lad
We are a tape and reel house,we use a variety of machines. If you are looking for low voulume, low cost and easy set up for you operators. I would look at Systemation MT-30, this is a good work-horse, I have used them for 10years for small runs, no
Electronics Forum | Sat May 13 07:03:16 EDT 2000 | Sal
guys, Currently running a very high volume product, with the gold fingers at the edge of the board masked off using Kapton tape to avoid any form of contamination during reflow and wavesoldering. I've heard alot of about the gold finger gloves, my q
Electronics Forum | Fri May 12 09:24:45 EDT 2000 | Ashok Dhawan
I need to install two SMD chips (0805) at one location. I refered to IPC-HDBK-001, fIG 6-24. When I solder the chips side by side, the ceramic side which is placed againgst solder pad- is already touching the solder. While I complete the solder joint
Electronics Forum | Tue May 16 05:45:46 EDT 2000 | Wolfgang Busko
Ashok: Couldn�t find that part in IPC-7711 either. I was just remembering that proposal from that thread mentioned. So you are still in that position I was at that time. Looking into IPC-D-275 (I have to admit that I have only an old issue in my offi
Electronics Forum | Fri May 12 04:46:32 EDT 2000 | Wolfgang Busko
There�s obviously still a lot of work to be done to get those "beasts" on the board. I wonder if anybody has solved the problems already and is able to say "we do it and it�s working well under the following conditions". I read the article in the las
Electronics Forum | Tue May 09 10:14:08 EDT 2000 | Stuart Hockensmith
hello- I am looking to add into my predominatly Fuji SMT lines a glue dispensing machine. I currently have for dispensing technology is a Camalot 3800 in one of my two lines. The second doesn't have any capability for glue , thus the reason for
Electronics Forum | Mon May 08 08:54:28 EDT 2000 | Lee Radney
Ok... Anybody got any quick, low cost ideas that can help me here? We run various panel layouts (all products are same width) thru our reflow oven. The problem is that due to the different layouts of our panels, the moveable center support chain
Electronics Forum | Mon May 08 12:02:14 EDT 2000 | Wolfgang Busko
The human machine is one of the most sophisticated know on this planet, "capable" of doing/thinking more than one task/thought at the same time. Sometimes the priorities get mixed up. So, if you have no simple computer or other gadgetry that�s able t