Electronics Forum | Sun Oct 30 19:22:11 EST 2005 | mrduckmann2000
Ken is not of this World! His equipment and "Programming Team" is perfect. The rest of the world uses "sticky" boards when programming. "ALL" the big guys...Panasonic, Fuji...etc suggest using the "sticky" method beofre running any production boar
Electronics Forum | Mon Oct 31 14:50:15 EST 2005 | frodriguez
Hi There. I use to suffer the same pain,specially when i had limited board quantities. You can use an antiestatic transparency attached to the board using Kapton Tape,than place the double sticky tape. This work perfect,kapton tape residues clean ve
Electronics Forum | Fri Oct 21 08:55:38 EDT 2005 | aj
All, I have been asked to review how we come up with costing of products. Basically, can anyone share how they do this i.e. If the machine can run 60 boards per hour what is a fair allowance for reel changes etc. I am guessing 15% . Any help/ad
Electronics Forum | Wed Dec 07 11:58:36 EST 2005 | derengmao
Could you help to tell what is the way to pick/place 0402/0201 using QSA30? Also do you know that without a VME bus Control B/D (illumination card for fixed camera), the new version software (ver.6.0 and above) will not initialize the vision system.
Electronics Forum | Thu Dec 08 12:06:29 EST 2005 | derengmao
Thank you for the info. I changed the "Light Cntl = 2" into "=1", the system tells "Vision not Init" but the machine works. If change to "= 0" then system tells more problem, and does not work. Do you have better idea about it? For feeder for 040
Electronics Forum | Thu Dec 08 13:05:51 EST 2005 | bobpan
In the scp.ini file you either check light control on or off.....i am not sure where you are putting numbers in at. You can use a slim feeder if it will fit onto your feederbase and if you do....you wont need the 2mm option turned on. What version o
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Fri Dec 16 12:50:34 EST 2005 | derengmao
I do have all tools for calibrate. The 4" plate is looked like for down-look camera. The big nozzle is for up-look camera. I did all the procedure in the handbook from Traning Center System from Quad. The up-look camera does see the nozzle, and passe
Electronics Forum | Mon Oct 24 16:10:07 EDT 2005 | Brian Davis, Compex Technologies
Dear Colleagues, We are looking at entry level AOI solutions. We are currently evaluating the Mirtec AOI MV-2HTL. We are also looking at Vitech because of their perceived "edge" in the industry. I know that this forum has approached this question be
Electronics Forum | Mon Jul 17 13:36:55 EDT 2006 | kjeffries
I appreciate your comments regarding the programmability of the Mirtec. What type of SMT machine do you use? How easy have you found it to transfer the SMT profiles to the Mirtec? How do you rate the Mirtec in handling top/bottom, multi-panel asse
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
winsouce.jpg)
.gif)
