Electronics Forum | Wed Sep 08 14:21:21 EDT 1999 | JohnW
| | | | Last Thursday I resigned from my position as manager of SMTnet. I want to personally thank all SMTnet viewers, editors, customers, colleagues, and others for your support to me in the creation and expansion of SMTnet over the last four years
Electronics Forum | Thu Aug 19 17:50:49 EDT 1999 | Stu Leech
| | | | | | We have developed a new process for removing moisture from surface mount devices. We have one site where PCB laminate drying has been reduced to 1.5 hours. A standard oven took 4 hours to do the job. I am looking for a firm who does large
Electronics Forum | Sat Aug 21 14:35:28 EDT 1999 | Stu Leech
| | | | | | | We have developed a new process for removing moisture from surface mount devices. We have one site where PCB laminate drying has been reduced to 1.5 hours. A standard oven took 4 hours to do the job. I am looking for a firm who does lar
Electronics Forum | Mon Mar 15 09:38:30 EST 1999 | Chrys
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Mar 15 15:42:16 EST 1999 | George Steele
| | Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there
Electronics Forum | Sat Jan 16 03:06:36 EST 1999 | Wirat S.
| | Our spec on voids is 30% ball diameter in the center. On the component to ball and pad to ball interface, we use 25%. To determine this spec, we asked around. I don't know of any studies that have been done to verify if this is OK | | | | Regard
Electronics Forum | Wed Oct 07 06:19:30 EDT 1998 | Charles Stringer
| | | Does sombbody know what DPM rate a good and reliable SMT assembly line (incl. solder paste print, assembly and feflow soldering) has? | | | DPM is Defects per million, usually measured on components. We run a process consisting of small to medi
Electronics Forum | Tue Jul 28 17:35:07 EDT 1998 | Brian Stumm
Steve, I know it is tempting to go for the cheapest method of applying conformal coatings but I must warn you. If you are a contract manufacturer then you don't want to limit yourself in the types of coatings you can work with. Just as soon as you se
Electronics Forum | Tue Jul 28 17:44:03 EDT 1998 | Brian Stumm
| Steve, | I know it is tempting to go for the cheapest method of applying conformal coatings but I must warn you. If you are a contract manufacturer then you don't want to limit yourself in the types of coatings you can work with. Just as soon as yo
Electronics Forum | Fri Jul 24 13:04:55 EDT 1998 | Dave F
| Hey youse guyz... | We're finally getting our first real job at the start-up I'm working at. It's actually a pretty unique little board too. Simple as all get out, but unique. You're not gonna believe what this goes into...guess? (I bet ya' you'll