Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika
Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont
Electronics Forum | Thu Sep 20 15:02:36 EDT 2007 | pjc
You do not always need test points designed on the board. Any ICT supplier will consult with you on that and after looking at your designs. Teradyne offers new and refurb'd systems for ICT, analog only or w/ Vectorless testing to ensure ICs have a co
Electronics Forum | Fri Sep 21 13:04:58 EDT 2007 | jmelson
Hello, Is anyone using an SMT pick&place machine to insert single contacts into PC boards? I have some boards that have 32 female contacts for 1mm pins, and 16 contacts for 0.5mm pins. I have been using Mill-Max for these contacts, getting the sma
Electronics Forum | Thu Sep 27 16:21:03 EDT 2007 | adlsmt
We have two, about 2.5 years old and 1.5 years old. We run all kinds of parts and get about 18K to 20K CPH. The pick accuracy is fantastic so have saved a lot of $$$$ by not having dump buckets full of parts at the end of runs. I could not be happier
Electronics Forum | Fri Sep 28 18:16:21 EDT 2007 | hegemon
Replacing Screen Printer with a dispensing system? If you have large complex PCBs you will lose a bit of time to say the least. That being said, we have had great success with an I&J Fisnar 'bot with positive displacement (auger) valve for dispensi
Electronics Forum | Fri Oct 05 21:29:43 EDT 2007 | mika
Hussman, I don't understand the last sentence of yours "but far from where this thread was going". What do you mean with that? I was just trying to give "Novaman" some infos. The fine old equipment You use from the old -20:s or so, is probably just a
Electronics Forum | Fri Oct 12 14:53:56 EDT 2007 | mika
Hussman, I'm sorry that I was a little bit tired and on top of that not so sensitive to your humour. Not so easy to understand everything for us Swedish guys. We have normally a great sense of humour over here and almost daily we have a big laughs a
Electronics Forum | Tue Oct 02 09:01:08 EDT 2007 | rgduval
Peter, Need a new hire? I'm up for moving . Considering the size...I'd guess that DBA or something similar is more along the right lines for you. xERP (Manex) may be way more than what you need. We were using it in a $20 mil company, and had a l
Electronics Forum | Tue Oct 02 10:08:20 EDT 2007 | allgood
Well apart from us being in the UK and I suspect you are over the pond, you wouldnt want to work with me for what I can pay! I am looking for a partner though......! We do punch above our weight already in that we must be Aegis's smallest customer
Electronics Forum | Fri Sep 28 16:49:48 EDT 2007 | davef
good * No IMC => bad Intermetallic growths are diffusion limited, and therefore the thickness of the intermetallic is given by: z^2 = (Do)(t)exp[-Q/RT] Where Do (m^2 s-1) is the diffusion coefficient, T(�K) is the temperature, Q (J mol-1) is the act
