Electronics Forum | Mon Nov 19 11:55:30 EST 2018 | reckless
Your thought about cheating like mad expresses what was going through my mind when I read that line.
Electronics Forum | Wed Nov 21 13:02:10 EST 2018 | reckless
What are they running? The YSM and other current Yamahas dont have much resemblance to the old GEM series. Did they change their philosophy on machine design? The old gems seem big, heavy and overbuilt. The newer stuff seems smaller, lighter, sle
Electronics Forum | Fri Nov 23 04:21:43 EST 2018 | reckless
Do you remember how tall if a component works on the sapphire? Basically it is a comet III, right? How did they speed the old comet up?
Electronics Forum | Fri Nov 16 01:05:34 EST 2018 | ushir
Hi all. I require some assistance please. I am looking for clamping blades for an old Ekra E5. Does anyone know where I could source these from? Thanks
Electronics Forum | Fri Nov 23 11:42:32 EST 2018 | dalsenkenneth
Hmm, I think I've heard that from my cousin before. I'll just ask him real quick.
Electronics Forum | Wed Dec 05 02:17:41 EST 2018 | oxygensmd
Hey there, Can you take a photo about your machine? For example my machine has a stencil-like blade only.
Electronics Forum | Fri Nov 16 07:55:17 EST 2018 | robl
Hi Prem, We used to place millions of Nickel battery tabs using Cobar paste. We found it particularly aggressive. Just contact your local Cobar distributor and ask them for samples of their most aggressive fluxed paste. Kind regards, Rob.
Electronics Forum | Wed Nov 21 05:57:30 EST 2018 | premkumar_haribabu
Hi Robl, Thanks for your qucik reply!! , i understand if we use aggresive flux that we can impove solder wetting over nickel plate vs PCB pads & we need to solder through 12 zones reflow oven. Prem
Electronics Forum | Tue Nov 20 09:10:57 EST 2018 | dekhead
What sensor are we talking about? Detecting entering / exiting machine? Detecting at load position? That is not part number but presumably connector number, but not locating in dwqs.
Electronics Forum | Tue Nov 20 09:43:31 EST 2018 | dekhead
Sorry, you said LT... correct dwg. On LT (assuming not very early software version), you can discount that sensor by selecting "Center Justified" for screen image...