Electronics Forum | Fri Jun 25 13:25:04 EDT 2004 | russ
Sounds like the wrong reflow profile was possibly used on this batch, Or you have a lead solderability problem. Usually you will pull a pad off of the board instead of the lead out of the solder joint. When a lead is torn from the joint it will ha
Electronics Forum | Fri Jun 25 14:39:59 EDT 2004 | Hoss
Any chance your potting compound was changed in the timeframe mentioned or the unit(s) were used under high heat stress conditions? If significant thermal expansion of your potting material happened and it is a hard durometer, it could shear at your
Electronics Forum | Fri Jun 25 18:33:45 EDT 2004 | jsloot
We are doing what I believe is unique from everyone else. We are using a .010 thick flex circuit board populated with the usual components, sot-23, caps, resistors,etc. It is mountd to a carrier plate with the edges taped down but I am having troubl
Electronics Forum | Fri Sep 10 18:17:21 EDT 2004 | jsloot
This is all very interesting. One obsticle I have to live with is I have an adhesive backing applied to the flex circuit before being placed on the pallet. Once gone through the reflow process the flex board goes through a couple of assembly stages a
Electronics Forum | Sat Jun 26 15:20:56 EDT 2004 | russ
Are you saying that immediately after the initial assembly process the boards work and then after these same boards sit for 15 days they don't? If that's the case I would suspect contamination maybe. what type of flux are you using and what is your
Electronics Forum | Mon Jun 28 14:48:56 EDT 2004 | jdumont
Yes i was looking around that site this morning and found everything i needed. Thanks to all. Basically what im trying to do is justify the expenditure of a new NO2 generator for our IC cabinets. Ours died a little while back and we have been using
Electronics Forum | Mon Jun 28 09:56:03 EDT 2004 | John S
Our company is transitioning to TS16949 this year from QS9000. We've begun to wrestle with the subject of improving the control of our production machine programs without creating unneccessary signoff's/documentation. Does anyone have a suggestions
Electronics Forum | Thu Jul 01 11:10:02 EDT 2004 | mfoster
Hi, Samsung has V 5.401 MMI posted on their site at http://www.samsung-smt.com under model CP33. You must register with your serial number, but there is no cost. Please let me know if you have any problems at mike.foster@DynatechSMT.com. Good luc
Electronics Forum | Thu Jul 01 14:47:27 EDT 2004 | Mark
I don't personally care for a DEK screener. I have used MPM and Deks. We had Deks come into our house and repacked them about a week later and sent them back. But we are a larger house and do lots of changovers. Now on the upside if you are low volum
Electronics Forum | Thu Jul 01 01:25:40 EDT 2004 | Alan
I am looking for information on Reel Tech Inc.I believe they are based in Indianapolis. I have looked on the net, but cannot find anything about them. I am looking for info about their tape and reel equipment, in particular the MT-7000 and the TR-300
