Electronics Forum | Sun Apr 09 14:20:17 EDT 2006 | greatexpectations
Hi, This setup was recommended. Target is 20,000 board output per day FUJI GL-541 Glue Dispenser (USED) 32K FUJI GL 641 SCREEN PRINTER (USED) 57K CP-643E CHIP SHOOTER 255K (150 FEEDERS) FUJI QP-242E IP3 110K REFLOW 8 ZONE (IS THIS ANY GOOD) 4
Electronics Forum | Wed Apr 12 11:09:55 EDT 2006 | Cmiller
So, you are going to be putting down about 3 million parts a day? How many shifts are you running? At 24 hours a day and assuming the machines never stopped placing parts (which is not possible) you would need a line that put down 125,000 parts an ho
Electronics Forum | Tue Apr 11 08:29:31 EDT 2006 | mapell
Hi Dougs I worked a bit a few years ago with a diode type soldering laser. I found laser soldering very application specific so make sure you send samples off to differnt companies to see actual results. You can get good results with a laser system
Electronics Forum | Wed Apr 19 10:23:47 EDT 2006 | George
If you are not OEM I would evaluate a chosen laser machine carefully. If possible, go and run some PCB's yourself at the manufacture's place before you jump into conclusions. If your work orders are small and very different, it might take a while for
Electronics Forum | Tue Apr 11 15:37:31 EDT 2006 | stockley
(Hey Cal how you doing?) I can't resist this. You can sort of do what you're hoping for but you have to be very careful. Let the component run out and let the machine get as far as it's going to go. Then go to "Software Options", "Test commands" then
Electronics Forum | Mon Apr 17 22:54:51 EDT 2006 | Darby
Short answer is - not really. According to the manual in Chapter 1-5 Supply devices (Feeders) overview "There are also available an 8mm tape feeder which handles 1005(0402) square chips". I have never seen one. The problem is that even an H nozzle is
Electronics Forum | Sat Apr 15 19:11:53 EDT 2006 | daxman
If I've been clear, the parts become offset as the XY table moves around, without fiducial correction. It's when it does a fiducial correction that the placement is alright. If the placement is excellent, and I just zip the table around...load posit
Electronics Forum | Sat Apr 15 09:07:22 EDT 2006 | samir
Amol, We pulled off this "hybrid profile" with a leaded solder paste. We recently got our tensile test report results, and our Pb-Free BGA / Pb Paste sample broke off during tensile tests at the pad/substrate interface, and not the joint. This ind
Electronics Forum | Wed Apr 19 06:47:58 EDT 2006 | QTEK Manufacturing Ltd. www.qtek.com
QTEK Manufacturing Ltd. launched a revolutionary new product last November at the Productronica Exhibition in Germany, which was the QTEK Splice Clip and Tape, which eliminates the awkward handling problems commonly associated witht the splicing proc
Electronics Forum | Tue Apr 18 12:34:15 EDT 2006 | Chunks
Outside the box: Can you retro your oven with a belt chain combo? I always order my ovens this way just in case. No pallet or carrier needed then. Can justify retro against the cost of the pallet or carrier. Two part epoxy instead of heat cure?
