Electronics Forum | Tue Feb 24 17:16:11 EST 2015 | grauen06
I was handed the task to develop a process to solder a BGA using topside heat only. It is a long story so I will spare the details, but I was wondering if anyone has ever attempted this? I have been going at it for a few weeks with fair results, but
Electronics Forum | Thu Feb 26 10:38:00 EST 2015 | swag
We don't have parts around anymore but I can offer a tip that might help. Our conceptronic is gone but the major issue we had with it was bearings going out on blowers. We rebuilt them in-house. Found a high temp. bearing through a bearing supplie
Electronics Forum | Wed Apr 01 08:23:05 EDT 2015 | emeto
All you have to do is to go on the floor when the machines are running and see yourself what the speed is. All machines show this data and even more. Most machines show some statistical data too - you can dig a little bit into that and you will get y
Electronics Forum | Fri Apr 17 10:28:23 EDT 2015 | SMTnetAdmin
http://www.smtnet.com/advertising/ - Starting at $97 you can't go wrong. SMTnet sends more traffic to websites than any other industry website, we guarantee it. Contact Derek Laborie, derek@smtnet.com for more information. Thank you for using SMT
Electronics Forum | Wed Apr 29 12:51:09 EDT 2015 | jandon
I have experience of Immersion silver and it's even more sensitive for all disadvantages mentioned above than Immersion tin. You can not go wrong with ENIG. It's little more expensive but in the end you save some bucks when you don't have to rework o
Electronics Forum | Thu May 28 09:39:19 EDT 2015 | emeto
Good luck Alexandru. I went through this years ago and it is a lot of fun. For the next 5-6 years you will learn a lot about P&P systems, as you will get your feedback from your customers(trust me it is going to be a lot and you will have to modify
Electronics Forum | Mon May 11 17:05:15 EDT 2015 | gregcr
Hi All, I have an old Asymtek AUTOMOVE 402 that actually worked pretty good. The PC died on it and I'm trying to get things running again. I have the DOS software, but I figure if I'm going to set it up I may want to get newer software. 1. Do you
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Wed Jun 17 07:08:58 EDT 2015 | armandogomez
Hello PAWEL before you go and buy a machine that cleans you pcb, have you check the current conditions where the pcbs are storage? hair, speck of dirt, fiber and other things sounds to me that the area where you work with these pcbs is not very clea
Electronics Forum | Sun May 31 04:03:53 EDT 2015 | alexeis
Hi, Our customers are performing these calculation on AOI machines and XRAY machines based on attributes. For this purpose, we have developed special software solution for these calculations which gathers real-time information and allows you to make