Electronics Forum | Wed Sep 08 04:10:14 EDT 2021 | leeg
Thanks Davef, we are using a mill max pogo pin on a small pcb that is panelised into a panel of 50, we have had a jig designed to get them straight instead of hand placing, there are 4 per pcb. We have followed the manufacturers guidance for stencil
Electronics Forum | Thu Sep 23 18:36:55 EDT 2021 | billmeye
Attached is a good starting point. We also have Mydata and have had many different people providing names. Some used standard units, other metric. Try to stick with all metric and use prefixes that match up with the component type and pin count if
Electronics Forum | Tue Nov 09 13:38:49 EST 2021 | bpoydence
Thanks for the reply. They apparently cant make a new one. If I understood right, the company had an employee pass away who was single point failure on the ability to make one. I found that very surprising, but even at the large company I recently
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Tue Mar 15 17:47:24 EDT 2022 | guyt
Hi, Has anyone had a issue with a MyData my12 dual camera system, were the calibration always shifts up after a few hours of use. It's not the mechanical calibration. it is like the machine loses it's software calibration co-ordinates ?? Any ideas
Electronics Forum | Tue Apr 05 12:32:16 EDT 2022 | proceng1
Here are the nozzles that soaked, but didn't get tinned. Since the solder joints also had yellow, I am wondering if the contamination is lingering in the solder pot, and getting on the joints. The Superior is never applied to a board. In the board
Electronics Forum | Tue Apr 05 17:42:57 EDT 2022 | amchirsan
I am looking to replace some spray guns that I have been using for a few years that are no longer reliable. You can see them in the attached picture. Does anyone had a brand/model that they would recommend? Any info or advice would be greatly appreci
Electronics Forum | Tue Apr 05 20:45:36 EDT 2022 | stephendo
Try adipic acid to clean your nozzles. It is a powder and can be awkward to work with as a result. But you might end up preferring it. Also look where the substance is not. There are two PTH joints without it. And that chip cap is closer to the PT
Electronics Forum | Mon Apr 18 19:58:22 EDT 2022 | cbeneat
I had the same question. We have custom nozzles made by Count on Tools. I believe we found urethane works the best for the silicon domed LEDs. Have you slowed the feed rate down on the feeder? Also adjust the top tape to the back slot on the feeder.
Electronics Forum | Wed May 25 12:09:52 EDT 2022 | stevemiles
Hi, I've had this problem with two DEK Horizon 03i printers. The first time it was the camera (firewire) causing the PC to freeze. The second time it was the firewire card in the PC that was the problem. Try moving the camera firewire cable to a d