Electronics Forum | Tue Mar 25 15:16:16 EDT 2014 | yuran111
machine controller BIOS loads only cyclically until pressed reset button on it - now checks the configuration and loading tasks load. hard drive I can take from the controller Siemens s27 example? motherboard came from s27 machine, and the same softw
Electronics Forum | Mon Apr 28 12:37:18 EDT 2014 | markhoch
Thanks for the replies. I guess I'm not really pissed, just a lil' grumpy perhaps. :) I just found it unusual to have to supply the Installation Engineer with ALL of his tools. It was explained to me that this was an unusual occurance, and I guess
Electronics Forum | Tue Apr 29 08:37:03 EDT 2014 | cyber_wolf
"Have you ever landed at home Saturday night, flew out Monday morning, just to have someone bitch that you are late, my suspicion is, NO!" Not-my-problem....that's the nature of the beast when you are a FSE. The travel requisite gets explained to yo
Electronics Forum | Thu May 29 19:26:06 EDT 2014 | wesleyintelli
Hi, We have recently installed a CP40LV+. Unfortunately the machine fails to do the pre-rotation (from feeder to library) when placing parts and as a result throws an error after scanning the part. However, it works when test picking the part. We h
Electronics Forum | Thu Jul 17 20:20:21 EDT 2014 | mac5
Hi June, The biggest issue with an OSP finish is as soon as the PCB sees a heat cycle (reflow or wave) the finish will begin to degrade. If you have a single sided SMT assembly with THT components installed downstream it works pretty good. But a dou
Electronics Forum | Wed Jul 30 07:41:08 EDT 2014 | williamaxler
I have seen similar issues in the past. 1. We had an issue when the relays were installed a leg was bent over. This cracked the epoxy base and allowed water and flux to get in. 2. We have had to bake relays after washing. We would cut open the
Electronics Forum | Mon Sep 08 16:49:28 EDT 2014 | jorge_quijano
I'm about to start a project to install some controls on our tooling for production, such, stencil, fixtures, feeders, press-fit tools, WS pallets, etc... How do you deal with that? I know there are some software solutions that may work, but what act
Electronics Forum | Mon Nov 17 16:23:14 EST 2014 | budro
The company I work for is installing a SMT prototype line, and I've been asked to determine the cost of operation. I know there will be cost for solder, solder paste, flux, stencils, glue, nitrogen, ect... I just want to make sure I'm not missing any
Electronics Forum | Tue Nov 25 10:46:19 EST 2014 | dph150
Hello, I had my flexa computer died I got a new computer a 4 port digi port usb to DB9. I have a CP743 that I can talk to just fine (It uses RJ45 connection). I can not talk to either one of my IP3 or my CP4 I get a nickname error when I try to p
Electronics Forum | Wed Nov 26 19:10:05 EST 2014 | caurbach
While I can't directly answer your question, we've had the same problem here occasionally. Our wash parameters are roughly the same as yours. It seems to be correlated to the diameter of the cap (larger caps will balloon while most smaller caps are