Electronics Forum | Wed Apr 23 19:10:24 EDT 2003 | MA/NY DDave
Hi Phil, There isn't one answer to your question. When dealing with really difficult assemblies that are pushing the process 50% might be considered OK. When dealing with run of the mill I personally would shoot for 98% or far better with a fast up
Electronics Forum | Mon Apr 28 13:56:19 EDT 2003 | hruiz
HI STEFAN, THIS IS WHAT YOU MEAN WHEN YOU SAID WRITTING WITH CAPS LOCKED??, OK THANKS FOR YOR ADVISE, YOU ARE RIGHT, THE PEOPLE ALWAYS WILL REJECT TO DO CHANGES, SPECIALLY AS YOU SAID WHEN THEY ARE USED TO WORK WELL WITH THIS MACHINES, RIGHT NOW I HA
Electronics Forum | Wed Apr 30 03:30:15 EDT 2003 | chrissieneale
Herman, LVHM is exactly what we have always done with our SMT machine. We use the Siemens 80F4 auto pick and place and have a HUGE set-up time for each run. And attrition problems (though i'm finding they are packaging related rather than machine rel
Electronics Forum | Fri May 09 09:29:25 EDT 2003 | gregp
Thanks for the response k_h, A few follow up questions... 1. 70-90 slots seems low for a one machine line. What is the maximum number of different parts on your worst case job? 2. Could the common parts be adressed by being assigned as "point of use
Electronics Forum | Wed May 21 10:01:36 EDT 2003 | caldon
Zestron Has PDF down loads available on the Product listed above. Also, Contact Jeff Stong or Guy Ramsey at ACI for a neutral opinion on these product. I know for a fact ACI has test each product and has recomendations. Sorry i can not provide deta
Electronics Forum | Wed May 21 20:09:32 EDT 2003 | MA/NY DDave
Hi President-MikeK and Carl, Well I just stopped by for awhile, and this was the first topic I read. Hey I am doing ESD research right now and I needed a break. Mike I have to agree more with Carl than you. Give your Data, without marketing hyper
Electronics Forum | Fri May 23 12:18:59 EDT 2003 | vortex
First off is your CP4 0402 ready? Before we could begin placing 0402's we had to have a vision upgrade. Once you have that or are sure your machine can handle 0402 then you will have to get 8x2 feeders. There may be a way to rig an 8x4 feeder but i'm
Electronics Forum | Thu May 29 08:28:16 EDT 2003 | davef
Teradyne says, "How does one evaluate the competency of a particular AOI system? At the highest level, all potential customers must judge any viable AOI system using the following qualities: * Throughput must be able to match the line rate on the man
Electronics Forum | Fri May 30 04:20:59 EDT 2003 | Ben
Hi all I am facing the problem with reoworking CSP component for high frequency application boards. Our customer do not allow us to use tacky fluxes due to high frequency application and component has low standoff ,and the ball pad and ball size is
Electronics Forum | Thu May 06 20:11:46 EDT 2004 | gregoryyork
It does sound like your leads are to long, speeding it up will reduce volume on lead and most will wick up the joint but when slow excess solder is left as long leads will have little flux left to aid drainage when it leaves the wave, thus giving a s
