Electronics Forum | Mon Oct 31 12:04:05 EST 2005 | erokc
bobpan, thanks for the reply. I currently have a Quad 100 with no vision, well it had vision but is blind now and the vision system is not supported. Anyway, I use it for my own production. I can leave it set up for my product runs. Technology ch
Electronics Forum | Wed Nov 09 10:34:52 EST 2005 | DannyJ
Ken, We have that same version of software and have never had this issue be a real problem. I can say that we have had the machine hang on shutdown after 8 hours of furious editing, but very few and far between. If you go to another virtual termi
Electronics Forum | Wed Nov 09 05:44:06 EST 2005 | grantp
Hi, It sounds like your vision is not setup right for this component, and it's rejecting some of them because they would be failing the test. This brings up a point we discovered. Don't use auto teach for the component if your using HYDRA or vision
Electronics Forum | Fri Dec 09 17:57:16 EST 2005 | mika
cameras > P2P (Part to Pad looking camera or upper looking camera) > front or rear >> select the corresponding camera that You have installed. After that: just save and follow the instructions on the screeen. By the way, an important thing is: You M
Electronics Forum | Wed Dec 14 13:11:27 EST 2005 | grantp
Hi, Thanks for the ideas, and I liked URL's idea of seeing if we can move the in feed sensor, that might hold the board wile the other is feeding in. Our in feed conveyer is also much faster than the oven, and I wonder if we can change that. I will
Electronics Forum | Wed Dec 21 08:31:13 EST 2005 | DannyJ
Hi AJ, First, I am not intimately familiar with your wave, but I will share some experiences I have had with other products. First, I would check to make sure that all of your heaters are working. Simply go to the electrical connections, remove p
Electronics Forum | Wed Jan 18 17:07:32 EST 2006 | gregoryyork
Sorry Bob Could not respond been away busy. Just to correct you, we did not copy the SACX as we brought ours to market at least six months before so how could we copy, it is also a little different, but nicely reassuring when the 'big boys' do some
Electronics Forum | Wed Mar 29 16:25:55 EST 2006 | Tech
Find you a good degreaser to clean the clutches with. Fuji used to ship Threebond with the machines but quit due to negligence on the part of the users if I had to guess. I believe the number was Threebond 2706. Now make sure you take a shop rag or s
Electronics Forum | Fri Jan 27 16:58:24 EST 2006 | solderman
Hi Ams, I often cringe when I read replys like the ones you got. I will give 'chris' the benefit of the doubt in that he is sincere in his response. However, there are people posting here with agendas to sell specific equipment. Without knowing
Electronics Forum | Mon Jan 30 16:30:55 EST 2006 | GS
Hi James, it could be the problem is due to residual of cleaner media entrapped under low gap of QFP 208 and 0,5 mm lead pitch. I remember in the past we had random problems of failure at test after board wash off process (DI Water wash). We met
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
winsouce.jpg)
