Electronics Forum | Fri Sep 15 14:29:10 EDT 2006 | bvdb
Thanks "j". There is absolutely no support for Fuji in New Zealand or for the older IP-1 and MCS/2 programming computer. We got the machine working by studying the FIP-1 Operation Manual and the MCS/2 Programming manual and a lot of trial and error
Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Sat Nov 20 15:18:40 EST 2010 | rodrigo
I did transfer the program from the MCS30. I noticed that next device numbers were changed in the F4G like you said (1,2,3). That was the first time I had wrong parts in the wrong locations (this is the second time) but I corrected the numbers to ma
Electronics Forum | Thu Mar 07 12:41:31 EST 2019 | rodrigo
Hi all, Our MCS30 hasn't been used for years because we use F4G now. Today I went to power up MCS30 because I need to transfer to F4G an old program but MSC30 is not working. It said all boot devices failed. We found a dead backup battery in one of t
Electronics Forum | Thu Apr 04 12:52:48 EDT 2019 | rodrigo
Hi, Our MCS30 had a bad backup battery in one of the boards. After changing the battery I got the all boot devices failed error. I managed to get a hold of some boot floppy disks and I can use disk1 to boot the MCS30 to a "$" prompt. I also have a di
Electronics Forum | Thu Dec 09 14:26:22 EST 2004 | Steve Gregory
Hi All! We've transferred our Electrovert MCS-1000 cleaner down to our Stafford, Texas facility, and I was wondering if any of you know of a referral I could give to them of any service organization that could work on the machine is if the need ever
Electronics Forum | Wed Dec 29 16:27:24 EST 2004 | Demar
Well I recently went with Circuitcam but I use the MCS platform still. To be honest I am not 100% sold on the software yet. I have already found bugs in the software that will likely never be fixed based on my outdated MCS platform. The only problem
Electronics Forum | Tue Jun 21 19:27:21 EDT 2005 | zl3vlf
Hello all! I'm looking for examples of part data for BGAs created in the MCS-16 environment (V3.20). I've heard using vision number 1, and vision type 10 works, but comes up with a transmission error. As these vision numbers are for chip components,
Electronics Forum | Tue Nov 23 00:20:10 EST 2010 | jamez
In flexa,the"Part Comment" field used for special instruct for kind of parts,it will be showed in the Report so that oprators can calrify know what to do.... i havent used MCS30&F4G,but i know machine can worked like your way well in flexa..... And i
Electronics Forum | Tue Jan 31 16:31:54 EST 2012 | rodrigo
Hi all, I used to be able to set a base program when optimizing in the MCS so that the new program would have the common feeders in the same location as the original... with a few exeptions. I'm trying to do this in the F4G and it is not working. I
