Electronics Forum | Fri Oct 12 14:13:30 EDT 2007 | stepheniii
If I need a lawyer I'll look you up. To get into that kind of detail you will have to look at the legislation itself in question. And I"m sure if there were any such loophole it would be plugged by now. But we had a customer that found something l
Electronics Forum | Fri Oct 12 17:53:27 EDT 2007 | muse95
One of the best sites for RoHS info I have ever found is http://www.pb-free.info/ The details about the separate-able-ness of a part, or the concentrations of the individual substances are not stated in the actual directive, they are stated in the
Electronics Forum | Thu Oct 11 16:26:40 EDT 2007 | jseagle
Have you created block offsets for each board in the panel? We have rotated baords in panels but have not had to use block fiducials, we just use board fids. We place 0402s and 16mil fine pitch on multiple boards in a panel with boards rotated 180
Electronics Forum | Tue Oct 16 12:34:40 EDT 2007 | actech
I have a V III that has a bad "Y" axis Bearing, it is different from the CSM 84 /V/VZ machines "It has dual bearing races on each side", Anybody have one for sale or a part number Philips list the machine as an "END OF LIFE" machine and support is li
Electronics Forum | Fri Oct 19 10:49:48 EDT 2007 | brulal1
Hi I will like to know what do you think about cleaning hand solder, my employee spend about 25% of they time to brush they hand solder with teddy pen cleaner, we used no clean solder wire. It�s not been the first time that I try to eliminate those c
Electronics Forum | Mon Oct 22 05:04:08 EDT 2007 | jkhiew
Hi, Recently we have encountered solder wicking on components termination (total of 13 pcs of components on one pcb)with Ag/Pd finishes during lead-free reflow soldering. The pcb is LF HASL surface finish and LF solder paste composition is SAC305.We
Electronics Forum | Wed Oct 31 12:06:08 EDT 2007 | devgru
We have the yestech systems and are very pleased with them. I would also suggest that you bring units into your facility to see a demonstration. It seems that there are really only two choices when it comes to the quick to program and easy to use ver
Electronics Forum | Wed Oct 24 01:44:49 EDT 2007 | darby
Will do Dave - we will have to eat humble pie though. Have just been informed that part is in fact correct value. Problem was caused by different markings on two different supplier cases. Marking on one was 222, on t'other twas 2201,this was interpr
Electronics Forum | Fri Nov 09 01:41:04 EST 2007 | reypal
Thank You Guys for all your input. The reason I raised this case that it was our customer challenge us on the physical outlook of the profile board rather than its functionality no matter the profile curves looks good. Yes, we have a procedure to de
Electronics Forum | Wed Oct 31 03:35:41 EDT 2007 | meritajs
Hello All, We have problem with one from our YAMAHA SMT mounter. It had weard defect. It gives error message"soft limit X over" when next step must pick up with head3. But all coordinat for next component do not exeed movable range. This failure happ