Electronics Forum | Mon Jul 03 03:15:35 EDT 2006 | bvdb
Thanks in part to help from the good people in this forum we've got our 1989 Fuji IP-1 working really great! We can run for hours without missing a beat (except to replace empty reels). Although I'm careful to lubricate as per the instructions the
Electronics Forum | Tue Jul 11 11:45:48 EDT 2006 | Rob
Hi Dougs, no Problem. Regarding the 1/2 size DIN41612, I can only find one range that is PIHIR compatable, and then that is only the male parts - according to the manufacturers the female usually goes on the backplane which doesn't tend to get intru
Electronics Forum | Fri Jul 21 03:51:06 EDT 2006 | Rob
Hi CKH, Here's some things to consider: 1) Moved by obstruction in/entering oven, such as nitrogen skirts 2) Incorrect air pressure/air leak in oven (large surface area on component) 3) Reflow temperature too hot & electrolyte/air in cap is expandi
Electronics Forum | Fri Aug 04 15:46:08 EDT 2006 | Chunks
Two reasons company B is asking $40 instead of $15-$20; 1. The set-up of their placement equipment takes time, thus the extra labor. Parts may be hard to get or what they norm keep in stock, plus storage of parts. 2. They know they can get awa
Electronics Forum | Wed Aug 16 13:52:24 EDT 2006 | russ
Oven settings are meaningless here. What does the board see? It is the paste we are concerned about not what the heaters are running at hehe. These solder balls are at the end of pad, which end? under the part or away from the part. I believe you
Electronics Forum | Tue Aug 29 10:36:09 EDT 2006 | Chunks
With the UP2000 that has vacuum board hold down, the Grid Loc hoses defeat the vacuum in order for them to exit the work table. Big boards require more girds, thus more hoses. Set-up between large and small boards takes time to remove or add the gr
Electronics Forum | Mon Aug 28 12:44:23 EDT 2006 | actech
WE have been running a leaded product for a few years and while the product is exempt from PB free regulations the components have been comming in lead free reciently and this caused little or no change in the process and or product, However! the Boa
Electronics Forum | Fri Sep 01 22:44:47 EDT 2006 | dmfausti
I have just been engaged again in SMT pick-n-place machines. My latest exposure is with Yamaha YV100 and YM84. I have been having some problem on feeders, especially on 1206 reel packages and above. The plastic cover on the reel does not peel off eas
Electronics Forum | Thu Sep 14 19:19:38 EDT 2006 | SWAG
I would try to panelize as big as you can for sure as you'll spend more time handling single boards than running anything. Additionally, this size is very close to smallest capabilities on GSM depending on your configuration. Fids on all boards in
Electronics Forum | Mon Sep 18 12:36:59 EDT 2006 | slthomas
A customer specs .1% thin film 0805s on one product. The parts that came in the kit were marked 1002, and I suspect they were just 1%ers that were sorted for the tighter tolerance. We were a few short, ordered the balance and got parts marked 103 w
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477