Electronics Forum | Wed May 03 13:34:04 EDT 2023 | proceng1
When we get a bad print at SMT, the operator uses the alcohol wipes and wipes the paste off the board. Then they use compressed air and another wipe. In most cases this is sufficient. Most vias are tented, but there still remains some solder sphere
Electronics Forum | Wed Aug 04 21:52:54 EDT 1999 | Dave F
| We're getting field failures in a high impedance portion of the circuit. Think the unpopulated pc card has contaminates because we were able to grow dendrites by applying a 9 volt battery across the suspected pad, placed a drop of de-ionized water
Electronics Forum | Wed Feb 03 16:45:20 EST 1999 | Mark Henebry
Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connector
Electronics Forum | Fri Nov 01 14:27:27 EST 2002 | kenBliss
Based on this thread Shouldn�t the handling systems allow the worker to do what is needed on the board during the stated hand operation so the worker has minimal direct contact with it. Now for the non sales pitch, sales pitch. Doesn�t it make the
Electronics Forum | Tue Mar 20 03:21:32 EST 2001 | hany_khoga
Dear Mr. Stephen: After all boards we lost & hard time we had, the only convencing solution for us is to run a good pc_motherboard (which is our product)to confirm the experiment. After that we need to remove the big BGA ,clean & flux the PCB then s
Electronics Forum | Wed Jan 14 00:02:10 EST 1998 | jerry
I have a problem! The solder on my pc boards look great comeing out of my reflow oven. They go thrue the rest of the prossese and at the end at the qc station it's cold or whitish or gray not shiny. does any one have a idea on how to correct this pro
Electronics Forum | Tue Jan 13 23:55:35 EST 1998 | jerry
I have a problem! The solder on my pc boards look great comeing out of my reflow oven. They go thrue the rest of the prossese and at the end at the qc station it's cold or whitish or gray not shiny. does any one have a idea on how to correct this pro
Electronics Forum | Wed Mar 10 15:09:34 EST 2004 | Jay
You can say "re-flow". It's related with the process. In order to assemble a PC Board containing lots of components such as PTH (Plated Through Hole) and SMT, usually, PTH type packages and components are soldered first using wave soldering process.
Electronics Forum | Sat Mar 20 06:18:58 EST 2004 | agp
I haven't heard of anybody yet who have done smt and reflow after thruhole and solder wave. Thru hole components usually have low resistence to heat and could easily burn when subjected to the 210deg-245deg.C reflow temperature. For pc boards with co
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th