Electronics Forum | Tue Apr 26 07:37:59 EDT 2011 | leemeyer
Have you performed the camera to nozzle calibration ? I can send you instructions for this if you need them.
Electronics Forum | Tue Apr 26 09:46:27 EDT 2011 | veeckm
Thanks for the reply. I have not performed the camera to nozzle calibration. Is this the same as the calibration of the vu3 camera in the manual? If you would please give me your instructions, any help is appreciated.
Electronics Forum | Tue Apr 26 10:14:06 EDT 2011 | leemeyer
The camera to nozzle offset calibration requires that you modify some of the mod codes once the offsets are calculated. This is not part of the VU3 calibration. Send me your email address so that i can attach a copy of the manual for you.
Electronics Forum | Mon May 09 16:32:05 EDT 2011 | veeckm
I got the camera nozzle offset corrected but after the machine runs for a while the offset will drift and its out the specs I set it to. Any help is appreciated.
Electronics Forum | Fri May 06 16:20:54 EDT 2011 | wrongway
hello Baez check the air line from spindle to the manifold make sure theres no small hole in it. some times with the spindle moveing up and down it may leak worse in some positions than others
Electronics Forum | Fri May 06 18:24:43 EDT 2011 | jbaez1
Hi Wrongway! thanks for your comment, I have already checked the air lines seems to be ok! anything else I could check?
Electronics Forum | Thu May 12 16:23:00 EDT 2011 | vickt
Is this a consistent issue? Have you tried running in "step mode" to see if it's really a handling related issue (ie Clutch, bearings, etc)? Good Luck
Electronics Forum | Thu May 12 16:24:39 EDT 2011 | vickt
Also... this is ONLY a pick issue? No issues with placement for those that you do successfully pick? Have the spindles been calibrated lately?
Electronics Forum | Fri May 13 09:11:01 EDT 2011 | vickt
And does this problem spindle exchange nozzles in the changer without issues? When was the last time the clutches were replaced? thx
Electronics Forum | Fri May 13 17:58:14 EDT 2011 | jbaez1
Hi VicKt! I will check the spindle nozzle changer issue this weekend, and the clutches were replaced since long,long time ago....probably more than 2 years..could be this the cause? for only one spindle? Thanks....