Electronics Forum | Wed Apr 16 07:31:45 EDT 2003 | brobinson
Anybody know a site that lists example oven profiles? I am looking to write a profile for 120 C for 15 minutes through a Vitronics Soltec XPM Reflow oven. Rather than guess, a rough starting time for belt speeds would be nice.
Electronics Forum | Mon Nov 15 18:51:46 EST 2004 | grayman
I would highly recomend an 8 zones (top and bottom heaters) oven as it has better flexibility than 7 zones. However, I would also would like to check for the heated length. Some oven has many zones but the heated length is small. Arman
Electronics Forum | Thu Jun 30 10:27:25 EDT 2005 | cyber_wolf
Ryan, I have never seen an oven "blow" parts off the pads. Whenever I have seen parts come off the pads in the oven, it was because the mesh conveyor or edge chain was jumping a sprocket tooth.
Electronics Forum | Fri Jul 01 11:03:11 EDT 2005 | smt_pro
We had this happen in a Heller 1808 oven when we placed Tant-A caps in glue (bottom side / no paste). We had our oven retrofitted to control the zone blower speeds. No more problem.
Electronics Forum | Tue Feb 12 14:18:48 EST 2008 | pjc
Without forced exhaust your oven will struggle to regulate zone temps, especially if a cooler one next to a hotter one. There should be no damage to the oven, just working harder to regulate itself.
Electronics Forum | Thu May 08 11:33:23 EDT 2008 | rkeck
I am looking for information mainly for installation instructions for the Infra Flow 5 oven. Anyone that has experience with this oven as far as exhaust requirements or has a manual they could access, please contact me.
Electronics Forum | Tue Oct 27 09:52:10 EDT 2009 | edmneb
Starting out, get a Vmole from ECD if you are worried about the cost. Fairly inexpensive, and you get a good in oven profiler, decent software that allows you to do some prediction and profiling tracking and lots of oven models preinstalled.
Electronics Forum | Wed Nov 11 15:37:36 EST 2009 | reash
I thought you made these ovens yourselves. Who is the actual manufacturer? Do you manufacture any of the ovens on your site yourselves?
Electronics Forum | Thu Nov 12 09:26:23 EST 2009 | cellis
Actually not true. We are the official distributor for the T200 ovens for the US. Some of the other ovens on our site are exclusively manufactured for Manncorp with our input on design. Regardless of any product we sell, whether distributed or our
Electronics Forum | Thu Oct 23 04:19:15 EDT 2014 | garteaga
Our reflow oven builds solder on one specific panel type. It will have solder buildup inside the oven. We then end up with small solder balls on our panels. We think it may be the solder paste, the screen printer is leaving a clean wipe under the pa
Capital Equipment Solutions - SMT | PCBA | TEST
Equipment Dealer / Broker / Auctions
113 S Main Street
Lodi, WI USA
Phone: 6083431779