Electronics Forum | Thu Nov 03 14:33:40 EDT 2016 | csm
Dear JummyB We noted that when the machine is initializing, and when all check step pass, we just push ready button and the main relay or contactor must be activated but is not, it looks like one Card in front of the machine where all the drivers ar
Electronics Forum | Wed Jun 16 14:07:15 EDT 2021 | oxygensmd
For example, I had the same problem on my Rehm oven. It was in calibration mode. The machine is going to maximum transport width but sensor wasn't reached and the machine stucked in calibration mode. Maybe there are manual mode for transport width a
Electronics Forum | Tue Jun 11 14:58:45 EDT 2002 | Chris Lampron
Hello Sean, We are currently using a Pin in Paste process to mount some through hole relays. This particular board has 72 relays per. We have cut the stencil to overprint the hole. By putting a small amount of solder in the hole to flux the lead, th
Electronics Forum | Tue Jan 31 15:51:04 EST 2006 | russ
Relays huh? I can tell you from previous experience that relays are not a good heat gun candidate. Did you check how long this part can withstand the 240? I do not know what the 4 setting is on a liester but it is probably well in excess of the 24
Electronics Forum | Wed Feb 09 08:54:42 EST 2000 | pascal MATHIEU
Hello friends , in order to try to reduce our labour cost , we are thinking to replace manual placementof PTH COMPONENTS by automatic unit which 'll be able to place relays ,and connectors . is there anybody on this forum to advise us on this topi
Electronics Forum | Mon Apr 24 03:33:35 EDT 2000 | Bob
I figured out how to do the first one (I used a multiplexer with addressable latch--works like a charm) Really, it's perfect. My new problem, though, is using this signal to get a string of lightbulbs on. Is a relay what I need? If so, who makes
Electronics Forum | Thu Sep 19 07:55:41 EDT 2002 | Claude_Couture
Dilbert, You are both right! Just above the schematic in the Smema standard it says: "Conformance to the standard may be achieved by the appropriate design of the equipment or by providing special adaptors which enable the equipment to meet the stand
Electronics Forum | Mon Dec 04 14:21:49 EST 2006 | jdengler
Todd, It's been a while since I have looked at this but I believe the IP-1 does not have a relay board for the feeders. +24 Vdc is wired to a pin on the connector and the I/O board (NO 3 I think) switches the ground. If you don't have +24 Vdc at 1
Electronics Forum | Fri Aug 08 02:24:04 EDT 2008 | jti
Hi, You were right on the money, the day after I posted, I recalibrated the LASER height .020 off on LA head, .01 off on LAIC, running perfect now. Secondary issue is a flicker on the monitor, the grid stays up after teaching XY coordinates, someti
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
