Electronics Forum | Thu Apr 12 00:56:20 EDT 2007 | Jani
Our SMT production and storage area is air-conditioned, constant temperature is maintained but the humidity is not controlled , the raw SMT material is stored in a "Drier" cabinet, but since we assemble hybrid SMT and thru-hole PCB assemblies, the SM
Electronics Forum | Thu Apr 12 13:04:47 EDT 2007 | slthomas
Handling requirements of all classifications of moisture sensitive devices is found in J-STD-033. It really isn't an issue for most parts unless they're going to reach reflow temperature again, which is unlikely unless you're removing a nearby compo
Electronics Forum | Thu Apr 12 22:00:58 EDT 2007 | davef
Search the fine SMTnet Archives, for instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=46687
Electronics Forum | Wed Apr 11 19:32:39 EDT 2001 | Adam
I'm trying to find information/articles describing the effects of temp and humidity on solder paste. Just recently we have gone through a change outside temperature and humdidty and have notice solderabilty problems with smt boards.
Electronics Forum | Wed Apr 11 22:05:58 EDT 2001 | davef
OA pastes are more hydroscopic than NC pastes. Hydroscopic. The capacity of a material to absorb and retain moisture from the ambient air. Sometimes this is compounded if you remove paste from the frig and let it warm to room temperature, because
Electronics Forum | Tue Apr 24 21:00:58 EDT 2018 | marlonbc
Hi All, Would just like to course through this concern on a product that we are contracted to assemble. It is mainly used for an automatic hand sanitizer dispensing product. By design there is a restrictive value of current that it needs to dissipat
Electronics Forum | Fri Aug 24 12:25:32 EDT 2007 | grics
What about when using noclean and alcohol based fluxes? Could humidity still cause issues?
Electronics Forum | Thu Sep 15 10:52:09 EDT 2016 | emeto
72F and 45% Humidity
Electronics Forum | Thu Aug 23 16:28:14 EDT 2007 | grics
I want to get a collective opinion from the forum... I was always under the impression that Humidity at SMT can be a disaster and can cause solder balls... But what about at the Wave/Selective solder? If every board or almost every board has solder
Electronics Forum | Wed Sep 14 04:09:21 EDT 2016 | jimmyh
We are enclosing our SMT room and will control the Humidity and Temperature of the room. Is there a standard for humidity and temperature for a SMT room and if so what is it. What is protocol if it goes out of tolerance? Do we stop production? Is