Electronics Forum | Fri May 08 17:55:37 EDT 2020 | cyber_wolf
The squish is determined by the spring in the nozzle. If Z0 or table level is out, you would see it on more than one component..most likely Make sure board thickness and component height are correct. Also make sure you have board support installe
Electronics Forum | Mon Jun 08 09:22:10 EDT 2020 | vinitverma
I guess the link you sent shows Top Side of the component. Send a picture of the bottom side - which the camera will see and I may be able to help.
Electronics Forum | Tue Jun 09 16:29:03 EDT 2020 | dilogic
Since rear feeder bank can be in three different positions, machine must know which one it is. Check in Machine Setup, Parameters - Feeders (see attached image). It that's set wrong, machine will try to reach position out of range and will hit end sw
Electronics Forum | Fri Jun 12 05:56:53 EDT 2020 | sssamw
I cannot see the logic connection between HIP and RSS or RTS, or between HIP and solder paste volume because volume is ok. Did you measured the BGA solder profile?
Electronics Forum | Thu Jun 18 12:43:45 EDT 2020 | emeto
I would say you check FAB drawing and see if there is any strange value on the stackup. Usually board house should inform you of these.
Electronics Forum | Fri Jun 19 03:17:45 EDT 2020 | rsatmech
We also don't inspect any things in incoming PCBs. We have CMM but will be used when we see any abnormality. Kindly advise me on this.
Electronics Forum | Fri Jun 26 17:30:54 EDT 2020 | jshepard77
Bob, Thanks. I'll reach out to you to see if it's worth salvaging this old thing.
Electronics Forum | Wed Jul 01 12:22:16 EDT 2020 | davef
Most people expect to see equipment listings in the MART. Check the nav bar on the left-upper part of your screen.
Electronics Forum | Fri Jul 10 05:17:50 EDT 2020 | unsung
This auction is mostly for spare parts you can see most of the equipment has been tempered with the MPM screen printer has its covers off as well on from the back ground of other machines. That's probably why theirs no good picture's of these machine
Electronics Forum | Sun Jul 26 07:52:35 EDT 2020 | sync40
Hello to everyone, Have you ever experienced soldermask bubbles inmediately after printed the soldermask itself? (for screen printing method of LPISM). I am not talking here about blistering or any outgassing defects after exposing to high temperatu