Electronics Forum | Fri Apr 29 15:17:54 EDT 2022 | glasscake
If the machine was working appropriately before the hard drive failure i would lean on the issue being a configuration issue. Lots of machines have options in their software for different sized motors, limit sensors, IO configs, ext. See if you cant
Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Mon May 16 20:01:38 EDT 2022 | ttheis
Still running our GSM's and some parts we see a high rate of "precise location" failures. We tried tweaking the component definition and feeder definition. We also tried copying to a custom feeder and doing a teach. Nothing seems to have ma
Electronics Forum | Wed Jun 01 04:31:30 EDT 2022 | ttheis
This is a 0603 ceramic capacitor. Thanks for the tip; this helped us figure out the issue. We reduced lighting and saw an improvement but still had issues. Looking closer at the rejects (see pic#2 in original post) there were some shiny spots on the
Electronics Forum | Sun Jul 03 03:52:40 EDT 2022 | acouto
I have some engine over load problems in the central reel, has it been identified that the external team misuses talcum powder for rubbers and many times we find talcum powder in the shafts, however will it be enough to cause the engine over load? Do
Electronics Forum | Thu Jul 14 03:16:18 EDT 2022 | acouto
Thanks for the feedback, I've been having some problems with the motor overload in the conveyor and central reel whenever there is cleaning by the external company. After analyzing I always find talcum powder and lubricant (it looks like cement) on t
Electronics Forum | Tue Jul 19 14:03:03 EDT 2022 | ttheis
Reading up I see there is a fixture (part# 1212100) but I am not able to find any information on this. Has anyone ever adjusted the focus of the PEC camera? Anyone know what this fixture looks like? One of our machines is out of focus but still able
Electronics Forum | Tue Jul 26 13:34:18 EDT 2022 | emeto
10x6 to 12x8 is ideal for most equipment. Too small panel is not good too for handling by humans and machines. 1.6mm you can use as and depanel on the router. 0.6mm you might need to run on SMT carrier, if you see warping.
Electronics Forum | Sun Sep 18 00:46:20 EDT 2022 | poly
This may sound silly but... I'm not sure where the glass scale is for the width axis. There is a Heidenhain rod 1020 rotary encoder connected to the motor that moves the width control, but I can't see any linear encoder / scale. I've given everything
Electronics Forum | Tue Oct 18 15:50:01 EDT 2022 | smith88
IPC states chips and cracks in glass body are defective if beyond specifications. Chips or cracks in glass body beyond the part specification, see Figure 9-18. • Cracked or damaged glass bead beyond part specification (not shown). On some glass