Electronics Forum: separate (Page 1 of 70)

Destacker will not separate 1mm thick boards

Electronics Forum | Fri Oct 24 19:27:28 EDT 2014 | wsp364

Do you know the maximum board size for that destacker? I left a message with a sales rep. btw- are you a Torch Lake guy???

Destacker will not separate 1mm thick boards

Electronics Forum | Tue Oct 21 09:07:35 EDT 2014 | wsp364

My UIC destacker does fine with 2mm thick boards. However, I have to hand feed the 1mm thick boards. I have seen vacuum board placers for small boards but not for large boards. I need to get a solution for 24" x and 16" y boards that are only

Destacker will not separate 1mm thick boards

Electronics Forum | Fri Oct 24 13:00:36 EDT 2014 | markhoch

I'd check into the ASYS LSB-03 Bareboard Destacker. It isn't a gravity drop style. It uses edge clamps to clamp the top PCB on the stack and then drop it on the transport rail. So it doens't destack from bottom to top, it destacks from top down. We

Do you know the MCPCB electronics and Power separation?

Electronics Forum | Mon Sep 09 22:05:51 EDT 2013 | mandysmile

Hello, Do you know the MCPCB electronics and Power separation?

how to assemble the blade on the PCB separator

Electronics Forum | Fri Jul 28 02:49:24 EDT 2017 | summertang

PCB Separator assemble manual for you

MPM AP25, separation problems

Electronics Forum | Fri Oct 28 06:55:53 EDT 2005 | pavel_murtishev

Hello! I suspect that our MPM AP25 has separation problems (poor stencil � PCB separation). I observe a lot of �dog ears� after print stroke. And this is 100% machine problem, I�m sure. What machine parts should I check first time to avoid separatio

Separate Oven for lead-free reflow

Electronics Forum | Wed Jan 04 10:10:54 EST 2006 | Amol Kane

One of my customer is asking the need for a separate oven for lead-free reflow. In all of my researches in lead-free transition, i have not read anywhere for the necessity of a separate oven for lead-free reflow....am I missing something here?? plea

Inner Layer Separation from Barrel Wall - Too Much Heat?

Electronics Forum | Thu Nov 17 20:23:55 EST 2005 | davef

We're with your customer. We believe inner layer separation is not linked to a heating excursion. What you are seeing is separation between the hole wall and the copper plating in the barrel of the hole on an unstressed PTH. Although, it's possibl

Re: PCB Support

Electronics Forum | Tue Nov 30 12:20:35 EST 1999 | Wolfgang Busko

Hi Steve, is it possible for you to get more than one PCB in a panel and separate them after assembly. Some kind of framepiece for support at the affected edge later to be separated should do it as well. My first ideas Wolfgang

MPM AP25, separation problems

Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob

From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.

  1 2 3 4 5 6 7 8 9 10 Next

separate searches for Companies, Equipment, Machines, Suppliers & Information

Solder Mask & Low Stand-off Component Cleaning

MSD Dry Cabinets
Used SMT Equipment Auction Spartronics

Easily dispense fine pitch components with ±25µm positioning accuracy.
PCB Handling Machine with CE

Best Reflow Oven
Benchtop Fluid Dispenser

World's Best Reflow Oven Customizable for Unique Applications