Electronics Forum | Mon Jul 10 09:28:25 EDT 2006 | Bobpan
Have you tried turning the theta manually to feel if it is stiff or having a harder time turning. This will cause Quadalign errors. also be sure the handling is not set to 10% on the theta this is also a problem.
Electronics Forum | Mon Jul 24 10:15:23 EDT 2006 | slthomas
Set-down height to low, iow, parts getting squashed too deeply into the paste. No mask between pads on fine pitch. Pads too wide for the pitch.
Electronics Forum | Mon Jul 31 21:33:58 EDT 2006 | seth
What is the distance from the reader to the segment, and can you use a filler gauge to set the gap or is there a special tool needed?
Electronics Forum | Wed Aug 09 16:46:49 EDT 2006 | nitro
We use the Tribol 930/100 Synthetic oil. Also, check the drive motor chain on the output end of the oven. I have seen the set screws back out of the drive gears, and it will kind of pop at times while running.
Electronics Forum | Thu Aug 10 06:33:59 EDT 2006 | saaitk
Can anyone advise if there are any industry standards for SMT Environments. I am setting up an SMT area in a new facility and need to know about temp, humidity, filtration levels etc.
Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Mon Aug 21 04:25:24 EDT 2006 | Rob
Larry, Cut the racist generalisations it doesn't help anyone. & if you want to ramble on about evil capitalist flux vs tree hugging flux then set up a new thread. Rob.
Electronics Forum | Tue Aug 22 15:26:37 EDT 2006 | Chunks
Can you afford or have room for the TP9 as well? Bobpan is right about the Quad, just commit, but the TP9 may off you more relief as well. They too are good machines, easy to learn and set-up.
Electronics Forum | Mon Sep 04 08:12:57 EDT 2006 | o.k.
hello everybody ! I am looking for electrical motors for double & triple siemens feeders. I think siemens only sells them as a complete set for a lot of money. what can I do ? thanks in advance for any reply.
Electronics Forum | Tue Sep 05 06:23:19 EDT 2006 | jonatf
Hi guys, I want to improve the set up of our printing machine(EKRA) especially on a 0.5mm thickness double sided boards.I find the support pins very time consuming.. any advice?? thanks.