Electronics Forum | Fri Dec 18 20:27:44 EST 2015 | rowsail
Thanks, I was able to get a PDF of the manual which describes: 1. INSTALL EXTERNAL THERMOCOUPLE PROBE. 2. TURN ON MAIN POWER: a. Press ENTER button b. Press F1 or F2 to scroll to SET UP mode c. Press F3 to select SET UP mode d. Display will read EN
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
Electronics Forum | Fri Aug 28 03:03:00 EDT 2015 | grimus
Thank you all for your advice. You are right this is two sides board, and dropped parts are on bottom side, and it is refered just to very light switches. I am using same temperature setup for top and bottom. What is interesting I am manufacturing t
Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old
Electronics Forum | Fri Dec 11 19:52:39 EST 2015 | dontfeedphils
I've dealt with MyData, Assembleon, Fuji, and Juki over the last 9 years with the majority being MyData and Juki so I'll talk about them. MyData was very nice for high mix/low volume due to the ease of setup and smart feeders, but I felt like I was
Electronics Forum | Fri Jan 15 17:42:14 EST 2016 | huske
We rarely do profiling so we don't need all the new fancy stuff. But when we do I get a piece of aluminum rod and an empty reel of parts (preferably a 12" reel) fasten the thermocouples and wrap the loose end around the reel. The larger reel gives
Electronics Forum | Sun Jan 17 20:36:49 EST 2016 | ttheis
I'm trying to configure the nozzle changers on my GSM1 machine because they were not configured when I bought it. I've figured out most of the setup with the UPS documentation, but I don't know what the I/O addresses are for the changers. Does anyon
Electronics Forum | Mon Jul 25 17:27:45 EDT 2016 | victoriajon
Up and running smoothly this morning, but got the attached error when switching from a reel feeder to a tray of the same part. We are getting this error message during setup - any suggestions are welcome. I am available to answer any questions that
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe