Electronics Forum | Thu Mar 10 10:06:08 EST 2005 | steve
OK all you Gurus here's one for ya. Customer is tinning wires with standard eutectic solder in a solder pot. There is a blue tint to the solder in the pot. After tinning with OA flux, which I will change to NC shortly, he has clear teflon insulation
Electronics Forum | Thu Mar 10 12:46:17 EST 2005 | jimk
Does anyone have experience in N2 supply source for reflow oven (1000scfh) other than N2 generator? Tanks, liquid, etc. We are in the developement stages of lead free processing and would like a quick, short term solution for providing N2 to a Concep
Electronics Forum | Tue Mar 29 13:14:28 EST 2005 | bobpan
Anyone familiar with making smema work on the ekra x5. I believe is was manufactured with a siemens (not smema)setup. We found the cables to make the siemens work but i am not sure if i can short a couple of inputs on the cable to make the smema func
Electronics Forum | Thu Apr 07 07:17:54 EDT 2005 | cyber_wolf
Colin, At this point you may consider calling in Mydata. I told you the basic things I have seen cause your problems. It sounds as if you may have a bad card, and or short somewhere. Possibilities: XWB Small booster on the front of the computer bo
Electronics Forum | Wed Apr 06 05:55:27 EDT 2005 | blueflag
At a previous company i worked at we had a quality inspector who had similar problems and it turned out that they were allergic to the nickel in the gold finish maybe it could be something similar but as the others have said, a dermatologist is the p
Electronics Forum | Thu Apr 21 10:34:06 EDT 2005 | patrickbruneel
Hi Y'all It would be valuable to the users of this forum to get a response from the original poster about his/her findings and solutions. It usually starts with the post of a problem, then opinions and experiences get exchanged but we never see a co
Electronics Forum | Thu Apr 21 12:48:23 EDT 2005 | imserv
I have a Siemens SP-120 and an HS-180 available. Can the SP-120 be used without a line computer installed? Possibly using the HS-180 computer? We are looking to use the machine for short production runs and prototying. Thanks in advance for an
Electronics Forum | Tue May 10 12:12:42 EDT 2005 | dougt
We had an outside vendor that built a particular board for us. When there were problems with the new board 9 times out of 10 the case of the oscillator was shorted to the lead as mentioned in the post above. The fix would be to draw some of the sol
Electronics Forum | Thu May 12 15:10:22 EDT 2005 | russ
Low volume - high mix in Singapore? Unless something has changed in the last couple of years this customer will be back shortly with a mess. I may be wrong on this and will accept correction from anybody but from my experience with them they will
Electronics Forum | Thu Jun 02 12:44:13 EDT 2005 | russ
Your inspection people will tell you what they need. We have some that prefer to stand while others sit. It has to do with chair / table / operator heights. e.g. tall table with a short operator they will want/need to stand and vice versa. Usuall