Electronics Forum | Mon Feb 10 22:29:07 EST 2020 | bilalfarooqi
Thanks all. I didn't check any further as I dont want to mess the midas head any further especially because I'm not sure how to take it out to work on it.
Electronics Forum | Fri Feb 14 12:37:08 EST 2020 | bilalfarooqi
Hey Rob, I don't know where the MOT cards are located on MY12 or how to change them. Do you have any documentation or instructions on how to change the MOT cards?
Electronics Forum | Fri Feb 14 14:35:44 EST 2020 | emeto
From what I remember, shut off machine, unplug cable/hose, unscrew 4 screws and the head is out.
Electronics Forum | Fri Apr 24 17:42:04 EDT 2020 | rodrigo
I checked and the fine theta motor is spinning. Thank you so much for the help.
Electronics Forum | Wed Aug 26 14:41:44 EDT 2020 | emeto
Part library is big enough problem. Whatever machine you pick you will be able to transfer XY, Theta coordinates as well as reference designators. This will help in programing a little, but this is all you will gain. all packages, vision algorithms
Electronics Forum | Thu Mar 25 16:29:39 EDT 2021 | jdengler
Your missing the point. The placement machine is the primary issue. Does this toy even say it can handle that component? If you have the ability try slowing the machine down when it is placing that component. Slow X, Y, and Theta axis. Jerry
Electronics Forum | Fri Apr 01 16:55:56 EDT 2022 | SMTA-64387687
It could certainly be the motor and/or the encoder. They do go bad. The other thing to look at is the component/package. Does it happen with only one specific component/package? It might be corrupted data. That happens, as well. But, most likely it's
Electronics Forum | Tue Apr 06 20:28:41 EDT 1999 | Scott McKee
| I need help in finding solder paste measuring equipment. | Height, length, width, area, volume after printing (off line): 1. Cyberoptics:1-800-745-6315 www.cyberoptics.com 2. Manix Manufacturing 1-215-953-9797 3. Theta Group 1-205-650-0535 4.
Electronics Forum | Thu Aug 30 14:14:27 EDT 2001 | dougt
James Take a board with double sided tape and run it with all the other parts "shorted". Make sure that the part is being placed by the head/spindle that will be used during a full run. Inspect the part after it is placed and carefully remove it a
Electronics Forum | Fri Jan 20 05:53:23 EST 2006 | dougs
i think it's more likely to be greasy/dirty shaft clutches, stand at the front of the machine and use the cam handle to turn the cam, while your doing this push up gently on the black top section of the shaft and try to turn the shaft, it shouldn't r
