Electronics Forum | Wed Feb 08 09:43:08 EST 2023 | charles_nguyen
Thank you for the above information but what I want to talk about is the PCB design aspect. Should there be any warning about it in the DFM?
Electronics Forum | Thu Feb 09 01:52:35 EST 2023 | sophyluo1985
YES, the role of the drying cabinet is to protect those electronic components, so that there is no need to seal the electronic components. As long as you keep the drying cabinet working properly, your electronic components can be stored indefinitely
Electronics Forum | Thu Feb 09 08:29:53 EST 2023 | compit
Take a photo of the other side of the PCB (not the front). It doesn't have to be RS232 at all - the connector is very popular.
Electronics Forum | Thu Feb 09 11:13:59 EST 2023 | sandima
Also didnt understand the jump from the 6th pin of the 2nd connector on the right side.
Electronics Forum | Thu Feb 09 21:30:35 EST 2023 | sandima
Sorry Michal I didnt get that. Do you think that they can be something else other than RS232?
Electronics Forum | Fri Feb 10 08:39:09 EST 2023 | klauss
Hi all, what may cause this things in attachments? Did it really rot as i thought? or it is something else.
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Fri Feb 10 13:02:00 EST 2023 | stephendo
Those capacitors look totally fluxed. I can't tell if the last photo is showing a concavity or a blob of stuff. I think it is a blob of flux and contaminants. Does it burn off with a soldering iron?
Electronics Forum | Fri Feb 10 13:30:31 EST 2023 | rwyman
Yes, that point remains unchanged. Just a general comment that there have been updates. e.g. re: desiccant re-use, certain devices no longer requiring bake-out, or bake times have been adjusted, and more.
Electronics Forum | Fri Feb 10 14:29:10 EST 2023 | klauss
It happened just after it came out of the reflow oven. And i guess the thing on the last photo is not blob of staff but the remaining part of termination of the cap. because when i try to iron soldering on it, i just cant. solders not sticking. on it