Electronics Forum | Thu Oct 21 12:44:07 EDT 2010 | swag
We issue extra parts like this: 8/2 caps and resis. - 40 over 8/4 caps and resis. - 20 over 8/4 IC's - 7 over 12mm - 7 over larger feeders + stick + matrix = the correct # req'd. These #'s were based on our first SMT lines (used equip.) and we made
Electronics Forum | Wed Dec 29 13:45:08 EST 2010 | methos1979
Chris, The red/blue filter as you call it (on the MV3L it's called HorzVert Sum I think) has become my go-to light source view for manual visual evaluation of flagged solder defects. Of all the lighting sources available, this one gives me the best
Electronics Forum | Mon Jan 10 18:08:29 EST 2011 | eadthem
vpblf I actually installed the Uniserver (apache mysql php) WAMP on the AOI machine and there is a setting to make it generate HTML board results, cant remember where off the top of my head. anyhow anyone in the inspection area can now open firefo
Electronics Forum | Tue Jan 11 13:12:58 EST 2011 | methos1979
Has anyone had any luck programming using the side cameras to inspect for defects on the sides of chip components? We recently had an escape of a damaged chip capacitor that was impossible to see from the top camera but was clearly visible with the
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Thu Dec 09 23:26:26 EST 2010 | jeffr
Philips (Yamaha) use a non standard NSK Ball screw and nut assembly. You should buy the genuine ball screw from your agent as the series of Ball screws used on these machines are the "NSK Super Precision series" which is not stocked by linear guide s
Electronics Forum | Wed Dec 15 15:07:41 EST 2010 | remullis
I have used Unicam software to create visual workaid documentation along with a setup sheet showing BOM in relation to feeder setups, etc. This was used in 1st piece verification, but also in the early days I had to do a 2 person validation. One and
Electronics Forum | Wed Dec 29 15:39:21 EST 2010 | ercdave1
Recently purchased a CSM84VZ, thinking that it was going to be a simple stand alone machine easy to program and i have now found out that is nothing like I expected. i have no computer to control the machine other than the hand held control that conn
Electronics Forum | Mon Jan 17 17:38:29 EST 2011 | bandjwet
All: I am reaching out to get some suggestions on the right flux to use as well as a recommended cleaning process for soldering a KOVAR RF shield using 80/20 Au/Sn solder to a ceramic hybrid. The recommended profile is 4-5 min at 280C and at least
Electronics Forum | Wed Feb 02 16:29:43 EST 2011 | remullis
I can explain our kitting process which was heavily software managed. For our Chipshooters we grouped setups of the optimum algorithym for less carriage movement, and grouping part numbers as much as possible. This was done with some high dollar sof
We are a global electronics manufacturing Solutions provider ....Our company supplies new and used SMT equipment, spare parts, consumibles, ESD supplies and services to a wide range of EMS companies.
Equipment Dealer / Broker / Auctions
Parque Industrial Nogales No. 5297 Zapopan
Jalisco, Mexico
Phone: 523316044491