Electronics Forum | Tue May 05 11:37:43 EDT 2020 | SMTA-Robert
5/5 Update: Our SIP restrictions have been extended to May 31. In spite of that we've notice a general uptick in business activity the past 2 weeks, as certain targeted restrictions are (either formally or informally) loosened. It appears the gove
Electronics Forum | Sun Apr 19 12:54:39 EDT 2020 | davef
A-620G doesn't require 100% wetting to the thermal pad. It requires 100% wetting to the land in the end-joint area. The end joint is the portion of the solder connection that is at the top [or bottom] of the connection. Look at 7.1.3 Solder Joint A
Electronics Forum | Wed Apr 22 14:16:22 EDT 2020 | rgduval
We prefered kapton tape to peelable mask, though, there is added time/effort to taping the boards, then removing the tape (if it's done hot, it can go pretty quickly). If you're at a volume where manual masking/mask removal is too time consuming, co
Electronics Forum | Wed Apr 22 20:41:39 EDT 2020 | SMTA-Samy
We use Wondermask 2211 and we haven't had issues with the material creating gunk in the pot. You might want to call TechSpray and consult with a product specialist who can better advise you on what's best for your application. Rob mentioned the wave
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Wed Apr 22 14:57:46 EDT 2020 | travishemen
It seems like we had a similar issue once on a CP643. If I remember right it ended up being either pre or post theta. The amplifier for the sensor quit working and it was trying to zero the theta motors before doing the cam. The LED indicator on t
Electronics Forum | Tue Apr 28 09:27:53 EDT 2020 | assuredtech
On power up, push and hold the F1 key during the complete boot up, this will force the machine to boot into it's I/O menu, this allows you to verify the conditions of all of the sensors and confirm if it is waiting on an input from a sensor. Most com
Electronics Forum | Sun Apr 26 22:47:42 EDT 2020 | autolab
Hello, We would like to manufacture the OBD II port automobile scanner from your firm. What we need from you? To manufacture the PCB, stuffed the components inside and manufacture the housing. Manufacture few samples, then thousands. What we h
Electronics Forum | Wed Apr 29 15:08:24 EDT 2020 | davef
Consider focusing on: * Regional suppliers that are within driving distance * Tier 4 suppliers LT $100M revenues STI used to advertise on SMTnet contact Mark McMeen mmcmeen at stielectronicsinc.com. Other quality suppliers in this tier are: Libra
Electronics Forum | Wed Apr 29 09:27:49 EDT 2020 | zombee
Dear friends, We have a pack of Philips/Assembleon pick and place machines, from CSM and GEM series. I want to set up a "new" Emerald machine, it had been working in Germany 1.5 year ago. It has 3-phase connector. I noticed that it was set