Electronics Forum | Sat Jun 28 07:29:36 EDT 2008 | proy
Chris I got both my SPMs running. The one with the touch screen; I think the touch sensor is worn out, 1 in 10 trys we can select the MAINTENANCE menu and run RESET properly, other areas always select fine. Your problem sounds like it is missing
Electronics Forum | Thu Jun 26 17:07:30 EDT 2008 | ck_the_flip
This is classic! This reminds me of the "mass exodus" of the late '90s when many so-called experts said their own "farewells". Here's one that I found, http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=156Message187
Electronics Forum | Sun Jun 29 11:46:26 EDT 2008 | johnnie52
I'm new at this and any help will be appreciated. I received cad data from a customer and need to get it loaded into a Topaz system. The data is for a single board but the production board is panelized and has edge rails. This means that the actual
Electronics Forum | Tue Jul 01 17:15:03 EDT 2008 | ronhodgson
I would like an interpretation of a solder fillet on a 5 side termination cap. (Ref: IPC-610, sec. 8.2.2.6). My question pertains to the definition of dimension F, and what constitutes the top of the fillet. Does the top of the fillet end at where
Electronics Forum | Wed Jul 02 02:46:44 EDT 2008 | tang
Hi Guys, I have few question would like to ask regarding pcb conformal coating: 1. Can I know which masking material is the best for easy apply, fast cure, fast & easy to remove after coating & baking. And no chemical reaction which will whiten the
Electronics Forum | Wed Jul 02 20:39:13 EDT 2008 | mika
Check this out .http://help.sap.com/saphelp_di46c2/helpdata/EN/7f/a7e7434d6011d2b438006094b9c9be/content.htm That's one way how to do it. Or read this: http://www.waterloo-software.com/limitations.html We have no relationship or what so ever with
Electronics Forum | Tue Jul 08 12:21:42 EDT 2008 | jwasyliw
Biggest differnce is tooling. Tooling cost with > a fixed pot - no tooling cost with programable > "moving"pot. > > There are various way to control > peel off with a moving pot. Depending on the > machine, you can use either the Z axis or the
Electronics Forum | Wed Jul 09 18:25:32 EDT 2008 | jmelson
There are temperature controllers that can be configured for a "safety stat" mode, so they blow a fuse to the main heater control if it goes, say, 10C or some reasonable fluctuation above the setpoint. It might be a VERY reasonable thing to add to y
Electronics Forum | Wed Jul 09 12:43:18 EDT 2008 | grics
I think this depends on what you are reporting as defects... I would place my inspection first, team up my Touch-up/Rework into one category. If for any reason I need to hit a joint after leaving my oven, that to me is classified as a defect and s
Electronics Forum | Wed Jul 16 10:31:29 EDT 2008 | vms
I would recommend a mpm, some one else would say a dek and some one else would come up with some thing else. Both dek and mpm printers will take the 29x29 stencils. And you have more money than you need for one of them. Shop around and then go and