Electronics Forum | Mon Feb 14 18:50:04 EST 2022 | emeto
Hello all, we have a laser machine in house(we bought it to cut foam) that looks pretty accurate. We are considering to start cutting our own repair stencils, so I am researching into the material side of it. Would you recommend what kind of materia
Electronics Forum | Wed Feb 16 20:50:57 EST 2022 | mihai_voivod
Its hard to answer your questions with fuzzy pictures, no background, or a schematics/BOM. Your best bet for good answers is to contact the manufacturer or obtain another board so you have spare parts. In the 1st picture The epoxy is there probably t
Electronics Forum | Wed Feb 16 23:20:40 EST 2022 | sarason
UAAA1280T is a Supervisory Circuit AIRBAG from Phillips/NXP ie voltage checking/current checking easily found in datasheet archive. TLC2274 is a Quad Low-Noise Rail-To-Rail Operational Amplifier CMD9936 could be a Dual MOSFET? What are you trying to
Electronics Forum | Fri Feb 18 22:14:24 EST 2022 | sarason
Yes something like that.ie a higher edge. Looking at your original picture I assumed no edge. If that doesn't work, then it is time to change the belt. But do check the frame with a straight edge. you may find a little twist or bend that may not be v
Electronics Forum | Wed Feb 16 23:26:48 EST 2022 | sarason
The question should be how does it ever stay on track. Replace the roller with one with closed sides and you wont have a problem. THe belts tension probably varies because of age and wear along its length, thus working for a few feet and then going o
Electronics Forum | Tue Feb 22 20:45:39 EST 2022 | jdengler
I think it is a configuration set-up issue on the monitor. I cannot find my MCS30 manual so I don't know what the settings should be. If you bought it from some who does MCS's try asking them. If not try the used dealers that advertise here and se
Electronics Forum | Tue Feb 22 22:39:22 EST 2022 | cirsol
Hi, Sorry I didn't see your previous post. I do have an update but will answer your questions first. {So you only rebuilt the MC HDD and didn't rebuild the Station PC? Am I right ?} Yes that's correct, we only rebuilt the MC HDD but were not able t
Electronics Forum | Mon Feb 28 21:30:34 EST 2022 | emeto
Couple notes here: 1. Try to shoot for 250C peak temperature. 2. Use all your 10 zones in profiling for more accurate profile. You should not reach your highest temp in zone8. Try to reach it in zone 10. 3. Go quicker. Your profile might be too long
Electronics Forum | Wed Mar 02 04:47:41 EST 2022 | shrikant_borkar
Dear All Hopefully you got the situation on SIPLACE D1i and SIPLACE D2i. Pickup up Place machines. Is the lead bend upward of SMT transistor detection is possible on this machine? If not is it possible to get it detects by optimising it's windows.
Electronics Forum | Mon Mar 07 15:03:57 EST 2022 | emeto
I wish traceability was not part of our job. If I have to pick, I will laser etch barcodes rather than use labels. Small footprint and fine pitch parts will always hate the label when you print paste. Pick thinner labels, keep away from problematic l