Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Thu Jul 03 17:22:03 EDT 2008 | mikesewell
On an ACE KISS machine we could program a drop in Z height to give a peel off angle after the component was soldered. Usually not necessary as the solder at the nozzle is falling away from the lead down the nozzle. If possible, we would program a fr
Electronics Forum | Tue Jan 24 18:21:22 EST 2006 | fredc
I have some old Fuji windmills here and I checked the usefull travel. It is approxiamately 1.5mm, the nozzles are suposed to have .3mm "preload" wich will take away from the usable overtravel. The windmill I checked is a reject that from when we rebu
| 1 |
