Make the Right Design Choices in Load Switching and Simulation in a High Current and Mechatronic Functional Test
Published: |
February 4, 2016 |
Author: |
Derek Ong, Lok Teng Kee, Chuah Rhun Chia |
Abstract: |
In a typical mechatronic manufacturing functional test setup, actual load simulations are usually done by connecting the DUT outputs to power or ground in order to establish either a high or low side driver. Each output is connected with different load and the test will either be sequential or concurrent. At lower power levels, these can usually be managed with general purpose switches. However, when it comes to higher power levels of currents more than 5 amps, such switching and loading might pose a greater challenge. Furthermore, critically in the manufacturing line, the tradeoff between cost and test time would have a great influence on the test strategy. This paper will present some key points to design a cost effective high power switching and load management solution.... |
You must be a registered user to talk back to us. |
Company Information:
More articles from Keysight Technologies »
- Aug 01, 2018 - Early Design Review of Boundary Scan in Enhancing Testability and Optimization of Test Strategy
- Jul 25, 2018 - Expanding IEEE Std 1149.1 Boundary-Scan Architecture Beyond Manufacturing Test of Printed Circuit Board Assembly
- See all SMT / PCB technical articles from Keysight Technologies »
More SMT / PCB assembly technical articles »
- Aug 20, 2024 - Thermal Interface Materials Drive Electronic Innovation | GPD Global
- Aug 20, 2024 - Underfill Materials Dispensing in Electronics Manufacturing Applications | GPD Global
- Jul 15, 2024 - Transforming LED Manufacturing: I.C.T Engineers Set Up Complete Production Line in Tajikistan | I.C.T ( Dongguan ICT Technology Co., Ltd. )
- Jun 20, 2024 - Case study: Precise Coating on Electronic Hearing Devices | ASYMTEK Products | Nordson Electronics Solutions
- Mar 19, 2024 - What is Underfill | GPD Global
- Browse Technical Library »
Make the Right Design Choices in Load Switching and Simulation in a High Current and Mechatronic Functional Test article has been viewed 841 times