Using Simulation to Optimize Microvia Placement and Materials to Avoid Failure During Reflow
Published: |
December 21, 2021 |
Author: |
Dr. Kourosh Kalayeh, Dr. Nathan Blattau |
Abstract: |
This paper cover the following points: - Objective 01: Preprocessing, - Introduction, - Objective 02: Automated FE Scripting, - Objective 03: Postprocessing, Reliability Analysis of PTHs, - Objective 03: Postprocessing, Manufacturability of Microvias... |
|
|
|
|
|
|
You must be a Company Information:
More articles from CALCE Center for Advanced Life Cycle Engineering »
- Dec 05, 2022 - No-fault-found and intermittent failures in electronic products
- Oct 31, 2022 - Microstructure and Intermetallic Formation in SnAgCu BGA Components Attached With SnPb Solder Under Isothermal Aging
- Jan 26, 2022 - Adhesion and Puncture Strength of Polyurethane Coating Used to Mitigate Tin Whisker Growth
- Dec 16, 2021 - Reliability Evaluation of One-Pass and Two-Pass Techniques of Assembly for Package on Packages under Torsion Loads
- Sep 08, 2021 - Modeling Temperature Cycle Fatigue Life of Select SAC Solders
- See all SMT / PCB technical articles from CALCE Center for Advanced Life Cycle Engineering »
More SMT / PCB assembly technical articles »
- Aug 20, 2024 - Thermal Interface Materials Drive Electronic Innovation | GPD Global
- Aug 20, 2024 - Underfill Materials Dispensing in Electronics Manufacturing Applications | GPD Global
- Jul 15, 2024 - Transforming LED Manufacturing: I.C.T Engineers Set Up Complete Production Line in Tajikistan | I.C.T ( Dongguan ICT Technology Co., Ltd. )
- Jun 20, 2024 - Case study: Precise Coating on Electronic Hearing Devices | ASYMTEK Products | Nordson Electronics Solutions
- Mar 19, 2024 - What is Underfill | GPD Global
- Browse Technical Library »
Using Simulation to Optimize Microvia Placement and Materials to Avoid Failure During Reflow article has been viewed 416 times
